What should you do if your iron has stopped steaming properly, and instead of a powerful stream, only miserable drops come out of the steam holes?
Most likely, the problem is in clogged holes.
Limescale, fabric fluff and other contaminants accumulate over time, preventing steam from escaping. But don't be upset - there are effective ways to clean your iron at home.
Vinegar Power: Dissolving Limescale
Vinegar is one of the most accessible and effective means of combating scale. Create a mixture of vinegar and water, combining them in equal parts.
Then pour this solution into the water compartment of the iron and turn it on to the highest temperature.
Once the iron is hot enough, begin to gently press the steam release button to release steam several times. Continue this procedure until the steam holes are completely clear.
Salt bath: soft abrasive
Salt is another effective remedy for cleaning holes.
Sprinkle salt on a piece of paper, heat the iron and iron the salt several times. The salt will act as a mild abrasive, removing dirt from the holes.
Toothpicks and cotton swabs: spot cleaning
To clean hard-to-reach areas, use toothpicks or cotton swabs dipped in vinegar or water.
Carefully clean each hole to remove any debris.
Prevention is the key to long service life
To avoid re-contaminating the holes, use filtered or distilled water in your iron.
After each use, drain any remaining water from the tank and wipe the soleplate of the iron with a damp cloth.
Conclusion
A clean iron is the key to its efficient operation and long service life. Clean the steam holes regularly to ensure your iron is always ready for new achievements in the fight against wrinkles.
We previously talked about using bright colors in the interior
Expert: Julia Tychino
